Things to pay attention to when installing wooden doors

1. After measuring the water on the door leaf, wipe it off with a dry cloth immediately.

2. When the facade is smudged, wipe it with a soft cloth. Use professional woodwork maintenance fluid to extend the life of the wooden door.

3, preparation tools: hammer, ruler, wood (brick) block, rope, pencil, Meisenli door cover, special solid connection parts.

4. Remove the dust: Before installing, set up the wooden bricks, remove the old powder or lime, and leave the original brick wall or concrete wall.

5. Place the wooden bricks: coat the wooden bricks with special glue, the position of the cushion cover and the wall, and fix the wooden bricks and the cover boards with small nails.

6. Install the door edge line: After the foaming glue is cured (usually 2-3 hours), remove the cover board.

7. Bracket, after the actual door edge line size is blanked, apply special glue to the groove of the sleeve, then gently tie the door edge line and the door cover and the plate. (If the door edge line and the groove fit loosely, you can use the veneer to tighten the inside of the door edge line).

8. In rooms with relatively high humidity such as kitchen, bathroom, basement, etc., the door cover is forbidden to directly touch the ground. It is necessary to leave a gap of 2-3 mm, and then seal with glass glue to prevent the product from being deformed by moisture. The back cover of the door cover needs to be waterproof and anti-corrosive to avoid the discoloration after the moisture is absorbed by the door line and the mold peeling and mold deformation.

9. The set of wires on the sleeve should be as close as possible to the wall. Because the wall is not vertical or the thickness is uneven, there is a gap between the door sleeve and the wall. The gap needs to be closed with a sealant.

10, the wall is the wallpaper, you must choose neutral glue instead of ordinary glue. Evenly apply waterproof glue on the contact part of the door sleeve line and the wall surface, so that the door sleeve line and the wall body are firmly combined. If the waterproof glue is exposed, it should be removed in time.

11. Foam glue is generally used for the gap between the door panel and the wall. A gap of 5 cm is generally required to facilitate longitudinal expansion and curing of the foam. Because the foam rubber is elastic and malleable, if it is too tight, the door cover will be pushed out and the wall will not bond tightly. The door cover will be curved and the door will not close.